But all of my IPs show up on the same subnet, i.e. So, why does wireless work and hardwire does not? The only thing I can come up with is that I am connecting directly to the router using wireless but am going through a switch when hardwired. And as my desktop is also hardwired, it might make sense that I could not access the NAS from that machine without using the IP. Well, I did a bit of experimenting and found that I can access the NAS via the name using wireless on my laptop but NOT the hardwire connection. : UnknownĮthernet adapter Wireless Network Connection: Node IpAddress: Scope Id: Ĭ:\Documents and Settings\Robert>ipconfig /all I ran a couple CMDs as follows in hopes that the info would be helpful.Ĭ:\Documents and Settings\Robert>nbtstat -n So, why doesn't the NAS show up in my workgroup? The HP desktop config SW and the backup program that came with the NAS (NTI Shadow) will not work with IP addresses and I would like to use these apps I cannot see the NAS in the MSHOME workgroup, which is used on all devices in my house (all my systems are running XP) I have used both static and dynamic IP addresses for the NAS with the same results The NAS is accessible but only using IP addresses, not with the network name "HPMEDIAVAULT" ![]() I have an HP MediaVault 2010 NAS device connected to the switch I have multiple computers on my home network, a wireless router and a switch in the office This issue is similar to the one described here however, disabling my firewall has no affect so I doubt it is a firewall issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |